Home> Products> Elevator Control System> Monarch Control System

Monarch Control System

(Total 20 Products)

NICE Series - an Integrated Solution for Elevators & Escalators

Monarch's Integrated Solution combines control intelligence & inverter drive in one compact package.
An innovative solution for OEM`s who value reliable state of the art performance at a highly competitive cost.
A NICE new comfortable experience from Monarch.

NICE3000+ Elevator High Performance Integrated Controller
Comprehensive Function Features
Direct-To-Floor
By the principles of distance, automatically generate the smooth curves from start of parking, no crawling and directly stop in the levelling position.

Optimum Velocity Profile Efficiency
The Elevator Controller will optimise the velocity profile based on the desired travel distance demand instead of floor number.

Advanced Door-Opening
Under the automatic operation state, the speed during stopping is less than 0.1 m/s and the gate signals effective, system shorts door-lock signal through advanced door-opening module and then opens the door ahead of time to enhance the elevator efficiency

Category Door Open Holding Set-Time
System can automatically identify different time to keep the open calls to open the door, instructions to open the door, the door to protect open, delay to open the door and to open the door inaccordance with the setting time.

Re-levelling
This may occur when the lift stops at the floor station, and a large number of persons or goods enter or leaves. The levelling fluctuates because of the elastic deformation of Elevator wire rope and the rubber. System is allowed to run automatically at the relevelling speed to the levelling station with the door open.

Self-Rescue Levelling
The elevator is in its normal operating state, but doesn`t stop at the correct level. If it meets the safety requirements to run, the lift will automatically run slowly to the nearest floor area, and then open the door.

Emergency Inertia Rescue Mode
Applicable for permanent-magnet synchronous motors only. When there is a power failure, system will short-circuit the motor phases through its contactor and produce a restraining torque when in motion. Based on the elevator inertia, the elevator will slide slowly and controller will open the elevator door when it reaches levelling position.

Emergency Self-Rescue Time-Out Protection
When elevator is at balance load or rescue device power capacity is inadequate. Long rescue time lapse is expected and accident may occur. This function enables the system to self-disable the emergency operation.

Elevator Position Auto Calibration
Each time the elevator enters the terminal floor zone, system will self-calibrate the position counter with respect to the 1st slowdown limit switch so that elevator over travel operation will be eliminated.

Fire Alarm Rescue Function
Enable user to preset the elevator designated homing floor when fireman mode is enabled

Home> Products> Elevator Control System> Monarch Control System

Copyright © 2024 Suzhou Keffran Parts Co.,ltd All rights reserved. Privacy Policy

We will contact you immediately

Fill in more information so that we can get in touch with you faster

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

Send